A break?
A break? No sadly, not us having a break. I mean things that do break. Ever have a thought in life that you seem to be repairing the same things again and again? The mate thinks it’s Mercury’s retrograde motion, I’m not so sure. My take on it is that a lot of things aren’t always fit for purpose in a marine environment. However, deal with things we must… About two weeks ago, maybe longer, we smelt an electrical burning smell in the middle of the night emanating from the main saloon. Mmm we thought, everything’s properly fused, we know it is, must be a smell coming in from outside. Alas no, it was the water pump. This pump had just been replaced earlier this year; I would expect a pump to last up to five years, not eight months. Out here you’ve little chance of taking anything back for a refund so we decided to change pump manufacturers from Whale to Jabsco. This, of course necessitated a new set of fittings as they use different connectors but that wasn’t the worst. No, the worst was that we didn’t have running water for a day or so and we had to use containers for everything. The mate was not a happy mate! Nor was I as we didn’t even have enough water for tea. As if that wasn’t enough, the dinghy air floor (recently repaired for the second time) deflated again. These air floors are pretty useless here, being made of PVC, but persevere we must. The mate made a temporary repair by stuffing a bit of a swimming noodle between floor and tube. ‘As good as anything’ I said. It still awaits permanent repair… Next, the Duogen started making weird noises in wind mode. Now, I have had the Duogen on and off so many times that I’ve lost count. We fitted new bearings, we greased the bits you are supposed to grease, we adjusted what you are supposed to adjust, we kissed it – and – it worked well for a day, before making its weird noise again. We blame the sand and general ‘grot’ in the wind out here. It gets everywhere and causes things to misbehave. However, it appears that more Duogen ‘fun’ is about to be had. Next, a bit of my tooth fell off. I was crunching a pork chop, King Henry VIII style and crack, that was that. It took so long to get a dentist appointment (still a week away as I write) that I thought we were back in the UK. As if all that wasn’t enough the forward heads decided to stop flushing. What we normally do is take a hose off (above the water line) and blow through with the dinghy pump. This worked – for two pumps of the handle. The real cause, we discovered, was all the fouling on the hull. So off we went in the dinghy with a brush and oh my, what a load of weed came off. We are nicely antifouled, but if you sit in Le Marin for long enough, this is what you get. We haven’t finished yet… five weeks ago, we applied for a final mooring buoy extension to start on 10 November and end on 10 December. We do it this way as it’s far cheaper than day by day bookings. It is the 15th November as I write and we still haven’t heard anything. Apparently the bookings manager is away until tomorrow, so we will see. Finally (we hope), the hinge on the forepeak hatch broke. I was simply adjusting it as I always do, when snap the bolt (a 12mm stainless steel bolt) sheared off. Quotes from the yard to rectify this were quoted in Eu85 per hour, they reckoned it could take up to two hours plus we’d have to remove the hatch and take it in to them. We’ll do it ourselves I said to the mate. One broken socket, one cut finger and it’s moved out of the remaining thread by about 1mm. We’ll get there I said to the mate. ‘I hope we don’t have to move from the buoy tomorrow’ she said ‘that forward hatch doesn’t close properly’. Oh la la… |